Safe All-In-One

From $33.95

  • 1 Gallon
  • 5 Gallon


DAICH Concrete Safe Cleaner & Etcher is an all-in-one solution for safely and effectively cleaning most concrete surfaces and also for preparing them for optimal adhesion performance prior to coating with paints and other coverings — including all DAICH decorative stone coatings for concrete.

  • helps remove dirt, grease, oil, mold and auto fluid stains for everyday concrete cleaning
  • effective etching action opens pores and adds surface profile to very smooth concrete surfaces. Optimizes penetration and adhesion of paints and sealers
  • low odor, water-based formula
  • bio-degradable and safe to use near glass and plants

How To

SURFACE PREPARATION:  Surface must be free of loose dirt and debris, leaves, dried peeling paint, etc. Use a stiff bristle brush or broom to clean out holes or cracks packed with dirt and debris to enable good contact with Cleaner/Etcher to bare concrete.  Wet the surface with a garden hose.

USAGE:  Wear rubber gloves and boots and eye protection during use. Pre-wet adjoining grass and plants. Work across the area in 10 ft x 10 ft (3m x 3m) sections. Pre-wet the concrete surface without puddling. Pour a small amount of Cleaner/Etcher directly onto the damp concrete and move the solution around with a bristle broom. Allow it to fizz on the surface for a few moments and then scrub the area with a bristle broom to further loosen and remove dirt. Rinse the section and proceed with additional sections in the same manner until the surface has been treated. More soiled areas or very smooth concrete, may require a second application and scrubbing. For ultimate final rinsing on outdoor surfaces, use a pressure washer to effectively remove all etching/cleaning residues and open up the pores.

COVERAGE AREA:  One gallon (4 litres) Daich Concrete Safe Cleaner & Etcher treats about 240 sq. ft. (23 sq.m.) where stronger cleaning/etching action is required.

For basic cleaning on most outdoor areas like patios, driveways, walkways, steps etc., Cleaner/Etcher can me mixed 1 part etcher  : 1 part water. The resulting diluted 2 gallon (8 liter) solution treats up to 500 sq. ft.

CLEAN UP:  Rinse all tools, material and personal protection with water before storing.

STORAGE AND DISPOSAL:  Keep container closed when not in use. Do not transfer contents to other containers. In event of spillage, rinse with clean water. Dispose of contaminated absorbent, container and/or unused contents in accordance with local, state and federal regulations.

CAUTIONS:  Avoid contact with eyes and skin, flood eyes repeatedly with potable water for 15 minutes. Wash hands thoroughly after handling. Do not take internally. KEEP OUT OF REACH OF CHILDREN. Keep container closed. Water-based product. Dispose of unused material as prescribed by local laws.



There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Other products you might need


Contact Us

We're not around right now. But you can send us an email and we'll get back to you, asap.

Not readable? Change text. captcha txt